Printing a cable management wall rack — settings, failures, final result
A 3D printed cable management wall rack from design to final part, including the warping and stringing failures along the way and the fixes.
My desk cable situation was out of control. Three monitors, a NAS, a Raspberry Pi, and a 3D printer all fighting for power strips. I designed a simple wall-mounted cable management rack in Fusion 360 and printed it in PETG. Here’s exactly how it went — including the two prints that failed.
The design
I kept the design simple: a 200 mm wide back plate with 6 cable routing slots and two keyhole mounts for M5 wall screws. The whole thing was modelled in about 40 minutes in Fusion 360. STL download is linked at the bottom.
Material choice — why PETG?
PLA would have worked fine indoors, but I wanted something that wouldn’t creep under load or warp in summer heat (Chennai gets warm). PETG hits a sweet spot — stronger than PLA, easier to print than ABS, and available everywhere.
Attempt 1 — warped corners
First print failed at layer 12. The corners lifted off the bed and the back plate came out banana-shaped. Cause: the bed was at 60°C (PLA default) instead of 75°C for PETG. I also skipped the brim, which was a mistake on a large flat part.
Attempt 2 — stringing everywhere
Fixed the bed temp. Added a 5 mm brim. But now the print had heavy stringing between the cable slot towers. This is the PETG retraction issue I mentioned in the Bambu review — default profiles aren’t tuned for it.
Attempt 3 — success
With the corrected settings below, the third print came out clean. Total print time: 47 minutes. The result sits flush on the wall and holds 8 cables without flex.
| Setting | Value |
|---|---|
| Material | eSUN PETG — Solid Black |
| Nozzle temp | 235°C |
| Bed temp | 80°C |
| Layer height | 0.2 mm |
| Print speed | 150 mm/s |
| Retraction | 0.8 mm at 30 mm/s |
| Brim | 5 mm, 3 loops |
| Infill | 25% gyroid |
| Total print time | 47 minutes |
Build log — 3 attempts to a clean print
Key lesson: Always add a brim on large flat PETG parts. The 5 minutes it adds to print time saves you from a failed 45-minute print.
Result
The rack has been on the wall for 3 weeks now. No flex, no creep, no issues. The keyhole mounts make it easy to remove — I’ve taken it down twice to re-route cables and it pops back on in seconds.
STL download: free, link in the WhatsApp channel (join below).
Stay Ahead. Work Smarter.
Get practical AI tips, automation ideas and useful technology tricks — one useful thing at a time. Follow the feed in any reader.